Next Steps

 Next steps are (not necessarily in order):

1. Purchase:
1. Lacquer
2. Power Cord Wire
3. Resisters
4. Capacitors
5. Veneer
6. Feet
7. Cowpasture Cans (ebay?)
8. Grill cloth?
9. Power Cord Strain Relief
10. Molding epoxy for capacitors and resistors
2. Generate Schematic
3. Generate Parts List
4. Determine the state of the speaker
5. Determine the state of the output transformer
6. Determine the state of the grill cloth

Some things to figure out:

1. What is the deal with the power switch, is there one on the back and the volume control? The hole for the rear mounted switch has some ragged edges leading me to think that someone added the hole later.
2. Type of feet? Maybe the same I did on the Packard Bell recently.
3. Find a label pitcher so I can reproduce one for the back of the chassis.
4.  I have no alignment procedure, will have to wing it. Good news is that this will be easy. Maybe consult Antique Radio Forum ( https://www.antiqueradios.com/forums/viewforum.php?f=20 )