Steps Forward, Steps Backward

So, applying the veneer was a bit more involved than I expected. I have applied veneer many times with full success but not on a curved surface. A learning experience. The second attempt will be using a vacuum bag to apply constant even pressure over the entire surface of the veneer applied to the bendy ply BEFORE attaching the front panel, bottom plate, and rear support.

Chassis Done Restoring

 A bit of a journey with this chassis. Didn't have a schematic so I had to make one. I went by the existing circuit but found out that someone had made some changes. Had to figure out thos changes and also determine the correct resistor values.

Veneer Fitting/Escutcheon Plating

 

Veneer

 Almost ready for veneer.

More Gluing

 

Test Phase, Start Cabinet

 

Chassis Done

 Chassis done except for alignment.